Storing stations

RADIO MODE

Note:

●If you want to use this feature, the RDS function must be activated.

➮Press the or button 9 to switch to the next station on the broadcasting network.

When using this feature, you will only be able to switch to stations that you have received once already. To do so, use either the Travelstore function or allow the automatic seek tuning feature to run once through the entire frequen- cy range.

Storing stations manually

➮Select the required FM1 / FM2 / FMT memory or MW / LW frequen- cy range (MW and LW are not available on the Essen CD31).

➮Tune into the station.

➮Press one of the station buttons 1 - 5 ;for longer than one second to store the station to that button.

Storing stations automatically (Travelstore)

You can automatically store the five sta- tions with the strongest reception in the region (only for FM). The stations are stored in the FMT memory.

Note:

●Stations that were previously stored in this memory are deleted in the process.

➮Keep the FMT or BAND (TS) but- ton 2pressed for longer than two seconds.

The station storing procedure begins. “T-STORE” appears in the display. After the process is completed, the station stored in FMT memory location 1 will be played.

Switching to preset stations

➮Select the memory level on which the station was stored.

➮Press the preset station button of the station you want to listen to.

Scanning receivable stations (SCAN)

You can briefly play all the receivable stations.You can set the scanning time to between 5 and 30 seconds in the menu.

Starting SCAN

➮Press the SCAN button 4.

Scanning begins.“SCAN” appears brief- ly in the display followed by the current frequency (which flashes).

Stopping SCAN and continuing listening to a station

➮Press the SCAN button 4again.

Scanning is stopped and the station that was tuned into last will remain active.