Installations
Supplied Mounting Hardware | Mounting Strap Use |
3. Attaching the Mounting Strap to the underside of the dash board, using screw.
Attach the back of the unit to the Mounting Strap using the support stem bolt and hardware.
If your car has no accessory position on the
ignition key switch (POWER SELECT switch)
The illumination on the front panel is
Sleeve | Bushing | Mounting Strap | Release | |
& Screws | and Screw | Keys | ||
|
Precautions
•Be sure to detach the front panel before you start in- stalling the unit.
•When mounting the unit in a car, keep the unit as level as possible. If the unit must be mounted at an angle, due to the design of the vehicle, make sure that the unit does not lit by more than 30˚.
•Choose the mounting location carefully so that the unit will not interfere with the normal driving operations of the driver.
•Use only the supplied mounting hardware for a safe and secure installation.
Mounting Example
Installation in the dashboard.
1. Install the sleeve in the dashboard.
2. Select and bend the appropriate tabs to hold the sleeve firmly in place.
Bushing Use
3. As shown in the figure below, securely fasten the screw, which has been inserted into the bushing, to the rear of the set.
Fire wall
The distance to the fire wall is various due to the type of the car. Be sure to secure the unit by properly inserting the bushing.
Caution
Insufficient fastening of the screw may cause some CD’s to skip.
button. The illumination is reset to stay off while the unit is not being played.
Reset button
Press the reset button with the point of a sharp object such as a
POWER SELECT SWITCH (Located on the bottom of the unit)
Change the position with a jeweler’s screwdriver, etc.
A: Your car has an accessory position on the ignition switch.
B: Your car has no accessory position on the ignition switch.
Be sure to press the reset button after changing the switch and connecting the lines.