Instructions — General Operation
See Traffic Safety & Precautions on page 3.
“Press”means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep.
“Time Out”When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity.
Vehicle ignition must be on. To turn unit on, press ON Button (2) or insert a tape.
Press the ON Button to turn the unit off.
Release for Detachable Faceplate
Push REL to detach face.
Power (ON) On/Off
When ignition on, press ON or insert a disc to turn unit on.
Power Off
Press ON to turn unit off. Unit stores current settings for source, station or track, etc. Antenna/ amplifier trigger wire shuts off voltage. (If faceplate still attached, display switches to clock.)
Setting the Clock
Turn the unit on. Press the CLK Button for four seconds until the clock starts blinking. (The display will change after two seconds. Ignore this and continue to hold for two more seconds.) Once the clock starts blinking, Press the /\ to set the hour, and press the V Button to set the minutes. (To change the minute indicator to the nearest hour (:00), you can press the MUTE Button. Press the CLK Button again to activate the clock.
Changing the Information Displayed
You can temporarily change the information shown in your unit’s display. You can also select which information has “display priority” and is shown in the display except for moments when adjustments are made.
•To change the display priority, press the CLK Button for two seconds. The display priority changes. The display priority choices are clock or radio frequency / ”TAPE”.
•To change the display temporarily, press and release the CLK Button to access the desired information.* After four seconds, the display changes back to the priority information.
Source (SRC)
Use SRC to select source - AMT, FM1, FM2, FMT or cassete (if already inserted).
12