Blaupunkt MP36 operating instructions Selecting the waveband / memory bank, Tuning into a station

RADIO MODE

Switching the RDS function on/off

If you want to use the RDS functions (AF and REGIONAL),

➮press and hold down the TRAF RDS button : for longer than two seconds.

The RDS function is active when the RDS symbol is shown in the display.

Switching REGIONAL on/off

➮Press the MENU button 7.

➮Press the or button 8 re- peatedly until “REG” appears in the display. “OFF” or “ON” is dis- played alongside “REG”.

➮To switch REGIONAL on/off, press the or button 8.

➮Press the MENU button 7.

Selecting the waveband / memory bank

You can use this device to receive pro- grammes broadcast over the FM fre- quency range as well as the MW and LW (AM) wavebands. There are three memory banks available for the FM waveband (FM1, FM2 and FMT) and one for each of the MW and LW wave- bands. Six stations can be stored in each memory bank.

To switch between the FM memory banks (FM1, FM2 and FMT) and the MW and LW wavebands,

➮briefly press the BND•TS button

<.

Tuning into a station

There are various ways of tuning into a station.

Automatic station seek tuning

➮Press the or button 8.

The radio tunes into the next receiva- ble station.

Tuning into stations manually

You can also tune into stations manu- ally.

Note:

●You can only tune into stations manually if the RDS function is deactivated.

➮Press the or button 8.

Browsing through broadcasting networks (only FM)

If radio stations provide several pro- grammes, you have the option of browsing through their “broadcasting networks”.

Note:

●The RDS function must be activat- ed before you can use this fea- ture.

➮Press the or button 8 to switch to the next station on the broadcasting network.

Note:

●When using this feature, you will only be able to switch to stations that you have received once be- fore already. To receive the sta- tions, use the scan function or the Travelstore function.

38