KeyCard anti-theft protection system

DEUTSCH

Two KeyCards are supplied with the unit.

Should you lose or damage a KeyCard, you can obtain a replacement from a specialist dealer.

•Slide the card as far as possible to the right, and remove from the front.

•Engage the control panel.

ENGLISH

If you are using two KeyCards, the settings are taken from the first KeyCard.

You can customize the following functions:

Station key assignment, bass, treble, bal- ance and fader settings, loudness, beep volume, LOW-EQ, HIGH-EQ.

The last state selected such as frequency band, station setting, AF, SCAN-TIME, seek run sensitivity, ON VOL (volume at switch on), SHARX, is also saved.

Your selected settings are therefore select- ed automatically when you insert your Key-

•Slide the card in the direction of the ar- row (2) and engage the control panel (Arrow 3).

The car radio is ready for use.

Should a KeyCard other than that belong- ing to the unit be inserted, CARD ERR” ap- pears on the display.

The unit switches itself off after approx. 10 seconds.

For safety reasons, the control panel must always be engaged whilst the vehicle is moving.

When leaving the vehicle, open the control panel and remove the Key- Card in order to prevent theft.

Teaching in a second KeyCard/ replacing a KeyCard

An additional KeyCard can be “taught in” whilst the unit is in operation with the first KeyCard.

ITALIANO FRANÇAIS

Card.

Switching on the unit

•Switch on the unit with ON.

To insert the KeyCard, disengage the con- trol panel:

•Press the knob 1: the control panel folds down forwards.

•Insert the KeyCard with the contact surface downwards, as shown in the diagram (Arrow 1).

Should a card other than a KeyCard be in-	To “teach in” a second KeyCard:
serted (e.g. a phonecard or credit card),
	•	Slide the first KeyCard in and switch
“WRONG KC” is displayed for approx. 2
seconds.		the unit on.
	•	Press DSC and use / to select
In this case, remove the card and insert a
		“LEARN KC”.
KeyCard for the unit.
	•	Press << or >>.
• Press ON to switch on the unit.
	“CHANGE” appears on the display.

Removing the KeyCard	•	Remove the first KeyCard and, with
Disengage the control panel as follows		“CHANGE” on the display, insert the
		new KeyCard.
• Press the knob 1: the control panel	When “READY” or “LEARN KC” appears:
folds down forwards.	•	Press DSC.

NEDERLANDS SVENSKA

ESPAÑOL PORTUGUÊS