Reception of traffic announcements with RDS-EON

Many FM broadcasters provide their service area with traffic messages at regular inter- vals.

Priority of traffic announcements	Automatic seek tuning start
ON/OFF	(During cassette operation)

All traffic program stations transmit a special signal parallel to the radio program. Your car radio is able to identify such traffic program station by this TP signal. The display will indicate “TP” to confirm that a traffic program station is tuned in.

Other radio stations do not air traffic announ- cements by themselves, but offer the possi- bility to receive the traffic announcements of another radio station within the same radio network. During reception of such a station (e.g. NDR3) “TP” lights on the display as soon as the priority of traffic announcements is activated. Then the display has to light “TA”.

If a traffic announcement is aired, your radio will switch to the traffic program station for the duration of the message and will switch back to the previous station after the end of the message.

“TA” lights up in the display, if the priority of traffic announcements is on. To switch the function on and off,

•press the TA button.

Warning beep

Whenever you leave the reception area of the traffic program station you are tuned to, you will hear a warning beep after approxi- mately 30 seconds.

This warning beep will also be released, if you press a preset button to recall a preset station without traffic program.

Switching the warning beep off

a)Tune to another traffic program station:

•Press the rocker switch 2 or

•press a preset button to recall a traffic program station.

If you leave the reception area of your traffic program station while you are playing a cas- sette, the car radio will automatically tune into another traffic program station.

If no traffic program station is found within approximately 30 seconds, the tape will be stopped and you will hear a warning beep. To switch the warning beep off, proceed as detailed above.

Adjusting the volume for traffic messages and warning beep

A default value is set ex factory for the volu- me of traffic announcements and the warning beep. You can change this default setting with the DSC function (see “DSC programm- ing, ARI, TA”).

DEUTSCH

ENGLISH

SVENSKA NEDERLAND ITALIANO FRANÇ AIS

b)Switch the traffic message priority off:

•Press TA.

“TA” goes out in the display.

PORTUGUES ESPAGÑ OL