Appendix, Overview of the DSC factory settings

LEARN KC To “define” a second Key- Card for use with the set. Please read the information under “KeyCard theft-pro- tection system”.

To quit the DSC programming mode and store the adjustment:

•Press DSC.

If the setting remains unchanged within 8 seconds, the system will automatically store the last adjustment. The display will switch back to the previous condition.

Overview of the DSC factory settings

TA VOL	: 4
BEEP	: 3
LED (Code) : 1
LOUD	: 4
RM	: OFF
LOCAL	: 1
DIS	: 1

Appendix

Care notes

Mechanism/cassette tapes

To avoid possible problems, you should not use cassette tapes longer than 60 or 90 minutes (C60/C90). Store your tapes in a cool place away from dirt, dust and tempera- tures exceeding 50 ° Celsius. Allow very cold tapes to warm up before playing them in order to avoid uneven tape transport. After approximately 100 hours of use, dust partic- les collected on the playback head or roller may lead to tape run problems and sound distortions.

Use a head cleaning tape to remove normal dirt build-up. For tougher cases, use a cotton swab (Q-Tip) soaked with alcohol. Do not attempt to clean by inserting a hard object into the player!

Specifications

Amplifier
Output power:	4 x 6 W RMS power
	acc. to DIN 45324/3.1
	or
	4 x 8 W max. power acc.
	to DIN 45324/3.2
FM waveband
Sensitivity:	1,0 ∝V at 26 dB
	signal-to-noise ratio
Frequency
response:	35 - 16 000 Hz
Tape player
Frequency
response:	35 - 16 000 Hz

Subject to modifications!