JVC KS-FX611 Prohibiting tape ejection, Repeat Function, Skipping the blank portions on the tape

During playback

Specify how many tunes ahead or before the current tune the tune you want is located.

To locate a tune ahead of the current tune on the tape

To locate a tune before the current tune on the tape

Each time you set the tune, the number changes up to ±9.

When the beginning of the specified tune is located, playback starts automatically.

Notes:

•While locating a specified tune:

–If the tape is rewound to its beginning, playback starts from the beginning of that side.

–If the tape is fast forwarded to the end, it is reversed and played from the beginning of the other side.

•In the following cases, the Multi Music Scan function may not operate correctly.

–Tapes with tunes having long pianissimo passages (very quiet parts) or non-recorded portions during tunes.

–Tapes with short non-recorded sections.

–Tapes with high level noise or humming between tunes.

Other convenient tape functions

Prohibiting tape ejection

You can prohibit the tape ejection and can “lock” a tape in the cassette compartment.

Press and hold TAPE 2 3 and 0 for more than 2 seconds. “NO EJECT” flashes on the display for about 5 seconds, and the tape is “locked.”

To cancel the prohibition and “unlock” the tape,

press and hold TAPE 2 3 and 0 for more than 2 seconds again. “EJECT OK” flashes again for about 5 seconds, and this time the tape is “unlock.”

Skipping the blank portions on the tape

You can skip blank portions between the tunes. (Blank Skip)

When this function is on, the unit skips blank portions of 15 seconds or more, fast-forwards to the next tune, then starts playing it.

1.Press and hold SEL (select) for more than 2 seconds.

2.Select “B. SKIP (blank skip)” with ¢ or

4 .

3.Select the desired mode with the control dial. The Blank Skip mode alternates between on and

off.

ON Ô OFF

Note:

When the tape reaches its end while fast-forwarding, the tape direction will be changed automatically.

Repeat Function

Press the RPT button while a tune you would like to hear over again is being played back. When the tape reaches the end of the tune, the tape is automatically rewound to the beginning of that tune and playback resumes from there. This operation will be repeated till the RPT button is pressed again.

Notes:

In the following cases, the Multi Music Scan, and Repeat function mechanisms may not operate correctly. These are NOT malfunctions; use the mechanisms to suitably accommodate the materials and situations.

•Tapes with tunes having long pianissimo passages (very quiet parts) or non-recorded portions during tunes.

•Tapes with tunes recorded at low recording levels.

•Tapes with short non-recorded sections.

•Tapes with high level noise or humming between tunes.

ENGLISH

9