JVC KD-R326, KD-R325 manual Preparing the remote controller, About discs, Discs that cannot be used

Page 5

Preparing the remote controller

When you use the remote controller for the first time, pull out the insulation sheet.

Insulation sheet

If the effectiveness of the remote controller decreases, replace the battery.

Replacing the lithium coin battery

CR2025

Caution:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

Warning (to prevent accidents and damage):

Do not install any battery other than CR2025 or its equivalent.

Do not leave the remote controller in a place (such as dashboards) exposed to direct sunlight for a long time.

Store the battery in a place where children cannot reach.

Do not recharge, short, disassemble, heat the battery, or dispose of it in a fire.

Do not leave the battery with other metallic materials.

Do not poke the battery with tweezers or similar tools.

Wrap the battery with tape and insulate when throwing away or saving it.

About discs

This unit can only play the CDs with:

Discs that cannot be used:

Discs that are not round.

Discs with coloring on the recording surface or discs that are dirty.

You cannot play a Recordable/ReWritable disc that has not been finalized. (For the finalization process refer to your disc writing software, and your disc recorder instruction manual.)

3-inch CD cannot be used. Attempt to insert using an adapter can cause malfunction.

Handling discs:

Do not touch the recording surface of the disc.

Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

Do not use any accessories for the disc.

Clean from the center of the disc and move outward.

Clean the disc with a dry silicon or soft cloth. Do not use any solvents.

When removing discs from this unit, pull them out horizontally.

Remove the rims from the center hole and disc edge before inserting a disc.

ENGLISH

5

Image 5
Contents KD-R326/KD-R325 To obtain the best possible performance from the unit Thank you for purchasing a JVC productDiscs produce very little noise compared Stop the car before operating the unitContents Initial setting Canceling the display demonstrationSetting the clock About discs Preparing the remote controllerDiscs that cannot be used Handling discsSource Basic operationsAutomatic presetting FM Improving the FM reception Manual presetting FM/AMSelecting a preset station Listening to the radioStopping playback and ejecting the disc Listening to a discSelecting a track/folder Selecting a track/folder from the listSetting Name Connecting the other external componentsListening to the other external components PreparationMenu operations Selecting a preset sound modeStoring your own sound mode Brightness Dimmer SETScroll *2 PRO EQGAIN*7 AMPMono *8 If BandTroubleshooting Using Bluetooth devices Specifications This unit does not work at all. Have you reset your unit? Precautions on power supply and speaker connectionsIn-dash mounting / การติดตั้งจอแบบ In-dash Do the required electrical connectionsPower cannot be turned on? Vehicle-specific Wiring Harness Separately purchasedRecommended connection KS-BTA100Please reset your unit