Turning Power On and Off, Turning Loudness On/Off

2 Press and hold the A.S.U. (Automatic Setup) button for at least 3 seconds to activate the A.S.U. mode.

"ASU" blinks in the display.

The unit automatically performs the following operations.

1.Activates the Auto Memory mode.

2.Gradually sets the Bass, Treble, Balance and Fader controls to their center positions.

3.Gradually increases the volume to the position 12 in the display.

4.Turns the Loudness on.

5.Ends the A.S.U. mode.

Turning Power On and Off

1 Press the POWER button to turn on the unit.

NOTE

The unit can be turned on by pressing any other button except the eject c button.

The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press the POWER button again to turn off the unit.

Turning Loudness On/Off

Loudness introduces a low- and high-frequency emphasis to compensate for the ear's decreased sensitivity to bass and treble sound at low listening levels.

1 Press and hold the LOUD button for at least

2 seconds to activate or deactivate the loudness mode. The display shows "LOUD" when the loudness mode is activated.

Adjusting Volume/Bass/Treble/

Balance (Between Left and Right)/

Fader (Between Front and Rear)

1 Press the MODE button repeatedly to choose the desired mode.

Each press changes the modes as follows:

→ VOL → BAS →TRE

FAD ← BAL ←

NOTE

If the Kor Lbutton is not pressed within 5 seconds after selecting BASS, TREBLE, BALANCE, or FADER mode, the unit automatically returns to VOLUME mode.

2 Press the Kor Lbutton until the desired sound is obtained in each mode.

NOTE

The BASS and TREBLE settings for each source (FM, AM, TAPE, and CD) are automatically memorized. These settings remain until you manually change them.

Displaying Time

1 Press the CLOCK button to display the time. The unit displays the clock time.

NOTE

Selecting any of the tuner, tape and CD functions while in the clock mode will interrupt the time display momentarily. The function selected will be displayed for about 5 seconds before the time returns to the display.

2 Press the CLOCK button to turn off the time and to show other functions.

Setting Time

1 Press and hold the CLOCK button for at least 2 seconds while the display is showing the time. The time indication will begin to blink (for 5 seconds).

2 Press the ZERO button while the time indication is blinking to set seconds to "0."

3 Press the HOUR button to adjust the hours while the time indication is blinking.

4 Press the MIN button to adjust the minutes while the time indication is blinking.

The time indication will stop blinking 5 seconds after the last adjustment. The time will automatically be set.

5-EN