dp INFRARED (IR) WINDOW
This window covers the remote IR sensor which responds to the IR signal from the remote control for selection of radio functions.
NOTES ON USE OF FRONT PANEL
1.Make sure the front panel is oriented correctly when sliding it into the front mounting plate, as it cannot be attached when
2.To verify correct panel installation, swing the panel assembly up into position until it locks easily into place. If any resistance is encountered,
NOTE: When the faceplate is in the upright position, press the release button to lower the faceplate away from the radio chassis.
3.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions.
DISC SLOT (20)
RESET BUTTON
THEFT DETERRENT(32) LED (31)
MOUNTING PLATE | CD EJECT |
| |
GUIDE (2 PLACES) |
| ||
BUTTON | FRONT PANEL | ||
| |||
| (28) | ||
|
|
PANEL
MOUNTING
PLATE
SETTING THE CLOCK
1.Switch the vehicle ignition and radio on.
2.Momentarily press the Time/Frequency (T/F) Select button dl so that the time is shown on the display panel.
3.Press and hold the Time/Frequency button until the time display begins flashing. While the display is still
flashing, press the Up Tuning (
) button to adjust the hours and then the Down Tuning (
) button to adjust the minutes to the correct time.
4.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal indication.
8 of 20