VM8022
WIRING
NOTE: The amplifier in this
radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.
NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
White/Black
Stripe
Left Speaker
(Front)
Parking
Fuse (15A)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire or radio fuse.
Red
FRONT SP | REAR SP |
|
|
Gray | Green/Black | Green Purple/Black | Purple |
| Stripe | Stripe |
|
Right Speaker | Left Speaker | Right Speaker |
(Front) | (Rear) | (Rear) |
(Blue)
(Yellow)
(Yellow)
A/V Media
Adapter Cable
IMPORTANT!
The pink parking wire MUST be connected to the switched side of the parking break circuit (the part that becomes grounded when the brake is applied).
3