BUTTON FUNCTION
BAND
Press BAND button to switch between FM/AM.
STOP
Press STOP to stop playing a track.
REP
Press REP plays a track repeatedly; long press REP play all tracks repeatedly.
PLAY
Press PLAY to play first tracks from CD. While it is playing a track, press PLAY to pause/ resume the track, the word “PLAY” will displays on the screen and blinking.
DISP
Press DISP button to display time, long press the DISP button to setup the time. When the time blinks, press H/M button to set hour/minute; hold H/M to increase H/M sequentially.
POWER ON/OFF
Press PWR to turn on/off the power.
VOLUME
When is on radio/CDP mode, turn the VOL button clockwise to increase the volume, turn anticlockwise to decrease the volume.
MODE
Press MOD to switch to CD mode. If no CD inside the cartridge, the LCD shows “__”. When you insert a CD into the cartridge, it reads the CD automatically, and displays number of tracks on LCD (If a CD is not readable, it displays “E”).
CLOCK
1) Press DISP to display clock.
Long press DISP to setup the time, while it is blinking, press H/M press to adjust the time. It will display the time, if you press DISP button again or left it for 5 seconds .
2)Press “H” once to increase one hour, long press to increase sequentially.
3)Press “M” once to increase one minute, long press to increase sequentially.
WIRING INSTRUCTION
Speakers Connection
This unit can mate with 4 as well as 8 speakers .Make sure Power is off before connecting.
Caution:
Do Not Short speaker wires to chassis ground . It may cause severe damage.
Ground Connection
Connect Black Wire to Ground terminal. If not found, connect it to the chassis instead.
Power Connection
First connect the red Wire (w/3Amp fuse ACC) to ignition output. battery power. Make sure no other device, such as switch, in between. Then connect orange Wire(w/1 Amp fuse block) directly to +12v
Antenna Connection
Insert coaxial connector to antenna socket.
Caution:
If a fuse is blown , only replace it with one of the sam e rating. Other wise may cause severe damage . Repeated blown fuse indicates potential problem(s) exists. A thorough inspection is recommended.
6 |
|
|
| 3 |
|