FM RDS
Setting :
SOURCE button : FM
FM RF signal
AM (MW) Auto Scan/Stop Level Adjustment |
|
Setting : |
|
SOURCE nMODE button | : AM (C8100) |
MW (C8100R)
FREQUENCY SELECT switch (C8100) : AM 10K
generator
antenna
terminal
0.01 ∝F
set
Carrier frequency : 98.00 MHz
Output level | : 35 dB (56.2 µV) |
Mode | : mono |
Modulation | : no modulation |
AM RF signal generator
30 ½ 15 pF |
65 pF |
AM dummy antenna (50 ½)
Procedure :
1.Set to the test mode. (See page 25.)
2.Push the SOURCE button and set to FM. Display
SHUF
REG
3.Push the preset 10 button.
4.Adjust RV10 so that the display indication is “13.2”. Display
SHUF
REG
Specification : Display indication : 13.0 to 13.4
Adjustment Location : See page 28.
set
antenna
terminal
Carrier frequency : 1000 kHz (C8100)
| 999 kHz (C8100R) |
30% amplitude |
|
modulation by |
|
1 kHz signal |
|
output level | : 33 dB (44.7 µV) |
Procedure :
1.Set to the test mode. (See page 25.)
2.Push the SOURCE button.
3.Push the MODE button and set to AM (C8100) or MW (C8100R).
Display
*1
SHUF
*2
TP
4.Push the preset 3 button. Display
*1
SHUF
*2
TP
5.Adjust with the volume RV1 on TUX10 so that the “AM” (C8100) or “MW” (C8100R) indication turns to “AM0” (C8100) or “MW” (C8100R) indication on the display window.
But, in case of already indicated “AM0” (C8100) or “MW” (C8100R), turn the RV1 so that put out light “0” indication and adjustment.
Display
*1
SHUF
*2
TP
*1 :
*2 :
Adjustment Location : See page 28.
– 27 –