Sharp HT-SL72 operation manual YourTVsize 60TV, Model HT-SL77 for 46 TV

3.SlotintheSoundBartothebasestandaccordingto

yourTVsize.

60"TV{_

_ _J} 70 II TV

___N	Groove to neatly
_	the wire in.

Caution:

•Be very careful to prevent the Sound Bar and Amplifier from falling when mounting on the wall.

•Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The Sound

Bar may fall.) If unsure, consult a qualified service technician.

•Mounting screws are not supplied. Use appropriate ones.

•Check all wall mount angle screws for looseness.

•Select a good location. If not, accidents may occur or the Sound Bar and Amplifier may get damaged.

•SHARP is not responsible for accidents resulting from improper installation.

•Do not let children dangle on the Sound Bar and Amplifier once it is attached on the wall as it can cause damage and injury.

Slot in the wire inside the groove or slit for better wire arrangement.

Suggestion of the

Sound Bars and

LCD TV arrangement.

1. Fix the brackets to the holes as shown.

Model HT-SL77 : for 52", 60" and 70" TV)

Model HT-SL72 : for 60" TV)

Model HT-SL77 : for 46" TV)

Caution:

Be careful not to

fix the bracket V

upside down. /%

SHARP designed the Sound Bar and Amplifier so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.

1/8" (3.2 mm)

3/16" _

(5 mm) _ 3/8" (9 mm)

7/8" (Min. 22 mm)

m

1 Select the correct screw point marks on the pattern paper according to your TV size. Fix the

pattern paper to the wall in horizontal position as below.

Wall surface

Pattern paper

2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

1-1/4" (32 mm)

3/8" (8-9 mm) _<_

Wall surface l

3Fix a wall mount plug (not supplied) into the hole

using a hammer, until it is flush with the wall surface.

1-1/4" (32 mm)

3/8/89mm)wa,!Ie