LCD MONITOR_________________________________________________________
The camera's LCD monitor can be viewed thru the side of the housing. Open the LCD monitor on the camera, rotate 180°, and then press it back against the side of the camera so that the LCD monitor is visible.
To view the image on the LCD monitor from the rear of the housing, Ikelite offers optional External Mirror #9290.95, which adheres to the outside of the housing. Then the LCD image can be viewed from the rear.
BATTERY AND TAPE____________________________________________________
Install a fully charged Sony battery on the camera:
Sony
Other brand batteries may not fit inside the housing. If the battery selected overhangs the camera tray, then the battery is too large and will cause the housing to leak.
Make sure you have loaded an appropriate digital cassette tape in the camera.
FINAL PREPARATION___________________________________________________
Remove the lens cap and cord from the camera. Otherwise, they may interfere with the housing seal.
The camera's auto focus feature is utilized underwater. For best results, move in close to your subject and use the
Power On/Off
Zoom Lever
Focus
Exposure
IN S T A L L A T IO N
CAMERA TRAY_________________________________________________________
The camera mounts to the tray, which extends from the back plate of the housing. DO NOT remove the tray from the back plate. Extend the camera's viewfinder to the rear.
Position the camera against the two stabilizing pins on the tray and secure with the tripod mounting bolt. The camera should fit easily on the tray and should be parallel with the sides of the tray.
Unfasten the velcro on the camera hand strap and leave the padded flap UP. Make certain that the lens shade has been threaded completely into the camera
to avoid any potential clearance or sealing problems when the camera is installed and the housing is sealed.
IN S T A L L A T IO N c o n t in u e d
INSERTING THE CAMERA_______________________________________________
Check that the clean
Unfasten the velcro on the camera hand strap as referenced previously and leave the padded flap UP.
Once the camera is mounted to the tray as described above, pull the housing controls of the housing body out to provide clearance for the camera. Align the back plate with the clear housing and slowly place the back plate against the housing.
As the camera slides inside the housing, make sure the lens shade on the front of the camera fits into the port recess in the front of the housing.
DO NOT force this installation; if the lens shade has been threaded completely into the camera and positioned inside the lens port and if the controls are out of the way and everything is lined up properly, the camera and tray will fit easily inside. The front should be flat against the housing and NOT tilted on one side.
HOUSING CONTROLS___________________________________________________
Slide the housing controls back in place making sure they properly align with the camera functions. Fasten the opposite lid snaps at the same
Operate each control to see how it works with the camera. Some controls such as start/stop will be used frequently. Other controls may seldom be utilized. Refer to your camera owner's manual for the proper function of each camera control. Look thru the back to be sure that you can see into the viewfinder.
When using the housing controls, especially the start/stop, DO NOT use excessive force because you could damage the camera.
CAUTION
Remove the lens cap and cord from the camera.Otherwise, the cord may interfere with the housing seal.If the housing controls are not properly positioned, they could interfere with the housing seal.
IKELITE UNDERWATER SYSTEMS
50 West 33rd Street • PO Box 88100 • Indianapolis, IN 46208 USA • 317.923.4523
Email: ikelite@ikelite.com • www.ikelite.com