After shooting (sea salt removal)
Make sure to perform maintenance on the marine case.
Salt crystal or dirt will accumulate inside the marine case if maintenance is not performed, and this may cause water leakage.
APrepare a container that contains fresh water that is five times more than the volume of the marine case.
•If only small containers are available, pour in fresh water that is equivalent to at
least five times the volume of the marine case over a few times, followed by performing salt removal in G.
Example: Container with volume | J Pour in water over 5 times |
equivalent to 1 marine case |
•The container must be big enough to allow the marine case to submerge fully.
•Perform salt removal for the grip as well.
BAfter diving, submerge the marine case in fresh water for 30 minutes without removing the camera.
C
Temporary salt removal
Shake the marine case in the upward, downward, left and right directions for at least 10 times, followed by rinsing it.
•If you do not need to take out the camera immediately, proceed to G for the actual salt removal.
DRemove the marine case and wipe off water droplets on the case surface using a dry cloth.
6