Motorola i290 manual Turn it on & off, Make a phone call

Your computer must be turned on, and you must have correct software drivers installed on your computer. If the phone is off when the USB cable is connected between the computer and the phoen, the phone will power up in charging mode. This mode allows the phone to charge fastest and quickest.

Note: If the battery is very low, the phone will not turn On, but it will continue to charge at a low rate.

If the phone is turned on while charging from a computer, it will not fully charge the battery. In this case, the battery charge will be maintained approximately between 80% and 95% of the battery’s capacity. Cables and software drivers are available in Motorola OriginalTM data kits, sold separately.

Tip: Motorola batteris have circuitry that protects the battery from damage from overcharging.

Turn it on & off

To turn on your phone, press and hold Efor a few seconds or until the display turns on.

To turn off your phone, press and hold

Efor two seconds.

Make a phone call

Enter a phone number and press Sto make a call, or use a voice name command. See “Voice name” on page 57.

Note: For best quality, avoid covering the internal antenna with your hand.

To hang up press E.

Essentials 19