Cloning Mode: Cloning Using the Cloning Cable | |
|
|
2. Connect the cloning cable to both radios.
NOTE: The target radiomustbeturnedon,but doesnot need to be in cloning mode.
3. Press under Clone to start the cloning. The “Cloning in Progress” screen is displayed followed by the “Cloning Successful” screen. If a problem occurs the “Cloning Failed” screen appears.
4. After cloning is completed, the target radio displays the following screen.
5.Turn target radio off then back on again to use.
6.Press under Reset to exit the Clone menu.
April 27, 2005 |