Sprint Nextel 2 manual Making Calls, Receiving Calls, Adjusting the In-Call Volume

Making Calls

Making calls with your Sprint Phone Connect 2 is as easy as making calls using traditional wired telephone service.

1.Before making a call, make sure signal and signal strength indicators are lit up.

2.Place a call by entering the desired telephone number.

3.When your call is complete, hang up or return the phone to the receiver to ensure that you can receive calls.

Receiving Calls

If you are using a new telephone number with your Sprint Phone Connect 2, simply share your new number with friends & family. When they call, answer the phone connected to your Sprint Phone Connect 2 device. If you're using your existing number, simply answer the phone as usual when the phone rings.

Adjusting the In-Call Volume

You can adjust the in-call volume in standby mode or during a call. Four volume levels are available, with level 1 being the lowest and level 4 the highest.

Adjusting the In-Call Volume in Standby Mode

The following steps illustrate how to adjust the in-call volume in standby mode.

1.Pick up the handset.

If you hear the dial tone, telephone service is available.

2.Enter # # 1 to adjust the in-call volume.

3.Press a key (1-4) to select the desired volume level.

4.Press the * key to save the volume level.

If you hear the confirm tone "beep", you have successfully set the volume level.

If you hear the dial tone again, the device has returned to the off-hook state, and you can proceed to configure other settings.

Note: If you hear the reject tone "beep, beep", you have pressed an incorrect key and failed to adjust the in-call volume. Wait until the device returns to the off-hook state and you hear the dial tone again. Then repeat steps 2-4to adjust the in-call volume again.

Installation and Operation 8