Important Notes, Compliance with FCC Regulations

IMPORTANT NOTES

Avoid installing the unit in locations described below:

•Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters.

•Places subject to constant vibration.

•Dusty, humid or moist places.

COMPLIANCE WITH FCC REGULATIONS

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause

undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with

-Application CD ACCESSORIES INCLUDED

-USB cable

-User Manual

GETTING STARTED

CONNECTING THE AC POWER CORD

1. Unwind the AC power cord fully and connect it to any convenient household 120V~ 60Hz AC outlet

2. Turn on the power and the Power LED indicator will light. Your system is now ready to play your music.

CONNECTING THE USB CABLE

1. To encode music from your records or from the Aux-in line, connect the USB Port of the Turntable to a suitable USB port on your computer via the USB cable provided.

2. Please refer to CONNECTING TO A COMPUTER FOR RECORDING section of this manual for detail.

the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

1. Dust Cover

LOCATION OF CONTROLS

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture.

2. Left Speaker

3. Pitch Adjust Control

4. 3.5mm Headphone Jack

5. Power LED Indicator

6. Power On/Off Switch

7. Auto Stop Switch

8. Right Speaker

9. Volume Control Knob

10. Tone Control Knob

11. 45 RPM Record Adaptor

12. 33/45/78RPM Speed Selector

13. Tone Arm Rest/Holder

14. Line-Out RCA Jacks (L/R)

15. AUX-IN jack

16. AC Power Cord

17. USB Port For Computer Connection

CAUTION:

This unit should not be adjusted or repaired by anyone except qualified service personnel.