Add and register a handset

You can add new handsets to your telephone system. Each handset must be registered with the telephone base before use. When first purchased, each expansion handset shows To register HS, see manual. The new handset should be charged without interruption for at least 30 minutes before registering it to the telephone base.

Make sure the handset is out of the handset charger and is put near the telephone base. Make sure the handset shows To register HS, see manual before you begin registration.

To register a handset to your SN1157/SN1196/SN1197/ SN6146/SN6147/SN6196/SN6197 telephone base:

. Press MENU on the telephone base

when idle. . Scroll to Settings, then press SELECT.

3. Scroll to Registration, then press SELECT. The telephone base shows Registering... Please wait.

. Press QUIET# on the cordless

handset. The handset shows Registering... Please wait. Then HANDSET X Registered appears on the cordless handset and the telephone

base, and both devices beep. The handset is now registered with the telephone base. It takes up to 60 seconds to complete registration.

If registration fails, the telephone base displays Registration failed and you hear an error tone. Start again from Step 1 above.

To register a handset to your SN6127/SN6187 telephone base:

•Put the handset into the telephone base. The base IN USE light turns solid red. The handset shows

Registering... Please wait. Then HANDSET X Registered appears on

the cordless handset. The handset beeps and is now registered with the telephone base. It takes up to 60 seconds to complete registration.

If registration fails, the handset displays Registration failed and you hear an error tone. Start again from Step 1 above.