Install the battery pack

Charge the battery pack for at least 12-15 hours before plugging the phone line into your phone.

1 Press in on the battery cover release and slide the cover down until it comes off.

2 Connect the battery pack connector observing the correct polarity (black and red wires) to the jack inside the battery compartment.

Do not exert any force on this connection. It could cause damage to the battery or to the handset. The plastic connectors will fit together in only one way.

Once you are certain that you have made a good connection, then insert the battery pack into the battery compartment. Do not pinch the wires.

3 Securely close the battery compartment cover by sliding it until it snaps into place.

4 Place the handset in the charging cradle.

When the battery is charged, the LCD will display “Initializing...” for 5 to 10 seconds.

Use only the Uniden battery (BP-490) supplied with your phone. Replacement batteries are also available through the Uniden Parts Department. (See page 2)

– 3 –