| adequate safety protection), Motorola provides holograms on its batteries. | battery charging |
| Consumers should confirm that any battery they purchase has a “Motorola Original” | Notes for charging your phone’s battery: |
| hologram. |
| Motorola recommends you always use Motorola-branded batteries and | • When charging your battery, keep it near room temperature. Never expose |
| chargers. Motorola mobile devices are designed to work with Motorola batteries. | batteries to temperatures below 0°C (32°F) or above 45°C (113°F) when |
| If you see a message on your display such as Invalid Battery or Unable to Charge, take | charging. |
| the following steps: | • New batteries are not fully charged. |
| • Remove the battery and inspect it to confirm that it has a “Motorola Original” | • New batteries or batteries stored for a long time may take more time to charge. |
| hologram; | • Motorola batteries and charging systems have circuitry that protects the battery |
| • If there is no hologram, the battery is not a Motorola battery; |
| from damage from overcharging. |
| • If there is a hologram, replace the battery and retry charging it; | Specific Absorption Rate |
| • If the message remains, contact a Motorola Authorized Service Center. |
| Data |
| Important: Motorola’s warranty does not cover damage to the phone caused by |
| non-Motorola batteries and/or chargers. | This model wireless phone meets the government’s |
| Warning: Use of a non-Motorola battery or charger may present a risk of fire, | requirements for exposure to radio waves. |
| explosion, leakage, or other hazard. | Your wireless phone is a radio transmitter and receiver. It is designed and |
| PROPER AND SAFE BATTERY DISPOSAL AND RECYCLING |
| manufactured not to exceed limits for exposure to radio frequency (RF) energy set by |
| Proper battery disposal is not only important for safety, it benefits the environment. | the Federal Communications Commission (FCC) of the U.S. Government and by the |
| Consumers may recycle their used batteries in many retail or service provider | Canadian regulatory authorities. These limits are part of comprehensive guidelines |
| locations. Additional information on proper disposal and recycling may be found on | and establish permitted levels of RF energy for the general population. The |
| the Web: | guidelines are based on standards that were developed by independent scientific |
| • www.motorola.com/recycling | organizations through periodic and thorough evaluation of scientific studies. The |
| • www.rbrc.org/call2recycle/ (in English only) | standards include a substantial safety margin designed to assure the safety of all |
| persons, regardless of age or health. |
| Disposal: Promptly dispose of used batteries in accordance with local |
| The exposure standard for wireless mobile phones employs a unit of measurement |
| regulations. Contact your local recycling center or national recycling |
| known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC and by |
| organizations for more information on how to dispose of batteries. |
| the Canadian regulatory authorities is 1.6 W/kg.1 Tests for SAR are conducted using |
| Warning: Never dispose of batteries in a fire because they may | standard operating positions accepted by the FCC and by Industry Canada with the |
| explode. | phone transmitting at its highest certified power level in all tested frequency bands. |
| | Although the SAR is determined at the highest certified power level, the actual SAR |
| | level of the phone while operating can be well below the maximum value. This is |
| | because the phone is designed to operate at multiple power levels so as to use only |
| 51 | 52 |
| | |
| the power required to reach the network. In general, the closer you are to a wireless | Safety and General |
| base station, the lower the power output. | Information |
| Before a phone model is available for sale to the public in the U.S. and Canada, it |
| must be tested and certified to the FCC and Industry Canada that it does not exceed | This section contains important information on the safe and efficient |
| the limit established by each government for safe exposure. The tests are performed | operation of your mobile device. Read this information before using your |
| in positions and locations (e.g., at the ear and worn on the body) reported to the FCC | mobile device. |
| and available for review by Industry Canada. The highest SAR value for this model | Exposure to Radio Frequency (RF) Energy |
| phone when tested for use at the ear is 1.45 W/kg, and when worn on the body, as |
| described in this user guide, is 0.69 W/kg. The SAR value for this product in its data | Your mobile device contains a transmitter and receiver. When it is ON, it receives |
| transmission mode (body-worn use) is 0.2 W/kg. (Body-worn measurements differ | and transmits RF energy. When you communicate with your mobile device, the |
| among phone models, depending upon available accessories and regulatory | system handling your call controls the power level at which your mobile device |
| requirements).2 | transmits. |
| While there may be differences between the SAR levels of various phones and at | Your Motorola mobile device is designed to comply with local regulatory |
| various positions, they all meet the governmental requirements for safe exposure. | requirements in your country concerning exposure of human beings to RF energy. |
| Please note that improvements to this product model could cause differences in the | Operational Precautions |
| SAR value for later products; in all cases, products are designed to be within the |
| guidelines. | For optimal mobile device performance, and to be sure that human exposure to RF |
| Additional information on Specific Absorption Rates (SAR) can be found on the | energy does not exceed the guidelines set forth in the relevant standards, always |
| Cellular Telecommunications & Internet Association (CTIA) Web site: | follow these instructions and precautions. |
| http://www.phonefacts.net | Product Operation |
| or the Canadian Wireless Telecommunications Association (CWTA) Web site: | When placing or receiving a phone call, hold your mobile device just like you would |
| http://www.cwta.ca | a landline phone. |
| 1. In the United States and Canada, the SAR limit for mobile phones used by the public is | If you wear the mobile device on your body, always place the mobile device in a |
| 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a | Motorola-supplied or approved clip, holder, holster, case, or body harness. If you do |
| substantial margin of safety to give additional protection for the public and to account | not use a body-worn accessory supplied or approved by Motorola, keep the mobile |
| for any variations in measurements. | device and its antenna at least 2.5 centimeters (1 inch) from your body when |
| 2. The SAR information includes the Motorola testing protocol, assessment | transmitting. |
| procedure, and measurement uncertainty range for this product. | Using accessories not supplied or approved by Motorola may cause your mobile |
| | device to exceed RF energy exposure guidelines. For a list of Motorola-supplied or |
| | approved accessories, visit our Web site at: www.motorola.com. |
