TIA Safety Information
The following is the complete TIA Safety Information for wireless handheld phones.
Exposure to Radio Frequency Signal
Your wireless handheld portable phone is a low power radio transmitter and receiver. When ON, it receives and sends out Radio Frequency (RF) signals.
In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for handheld wireless phones. Those guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies:
ANSI C95.1 (1992) *
NCRP Report 86 (1986)
ICNIRP (1996)
*American National Standards Institute; National Council on Radiation Protection and Measurements; International Commission on
Safety
Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature. For example, over 120 scientists, engineers, and physicians from universities, government health agencies, and industry reviewed the available body of research to develop the ANSI Standard (C95.1).
The design of your phone complies with the FCC guidelines (and those standards).
Antenna Care
Use only the supplied or an approved replacement |
|
antenna. Unauthorized antennas, modifications, or |
|
attachments could damage the phone and may |
|
violate FCC regulations. | Safety |
Phone Operation | |
NORMAL POSITION: Hold the phone as you would |
|
| |
| |
any other telephone with the antenna pointed up |
|
and over your shoulder. |
|
53