RCA 004-000-00345-4 Getting Started General Controls, EN Unpacking the system, Back View

Getting Started

General Controls

EN Unpacking the system:

You should have the following:

•one main unit (with 2 main speakers);

•one remote control;

•one AM loop antenna;

•one user’s guide;

•one safety leaflet.

•Owner and registration Card

Back View

Connecting the Speakers

Match the red wire (on the left speaker) to red terminal for the left speaker (L) on the back of the unit and the black wire (on the left speaker ) to the black terminal for left speaker (L). Follow the same procedure to connect the right (R) speaker.

Speaker Wire Connection

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

Main Unit

5 DISC CHANGER

S I M U L T A N E O U S P L A Y A N D L O A D S Y S T E M

					CD-R / RW COMPATIBLE
ON
STA NDBY	IR SENSOR
	STANDBY
L		PRESET EQ	DIGITAL	TUNING	TUNE • PRESET
GAME	SOURCE	TIMER
•MP3•
R
	DIMMER•DEMO	CLOCK	PROG • SET	BAND	REPEAT
	CD DISPLAY		AUTO PROG		BASS BOOST
	DECK	1			DECK 2
	PLAYBACK/ RECORD				PLAYBACK

EN

DIGITAL TUNING (SKIP BACK- WARD) — Decrements radio frequency, preset down, goes to the previous CD track or setting option.

			DIGITAL TUNING	(SKIP FOR-
			WARD) — Increments radio frequency,
			preset up, goes to the next CD track or
	OPEN CLOSE		setting option.
	•
			PLAY / PAUSE — Plays or pauses
		DISC	CD.
		SKIP
			TUNE•PRESET	— Stops CD track,
			Sets tune or preset mode.
			PROG•SET - Enters program mode
			for CD and Tuner; Applies new set-
V		L	tings for Clock and Timer modes.
		RO
	OLUM E CONT

FMANTENNA	LOOPAM	2
1

	+
	L	Ω
3	_ _	6SPEAKERS
	R	MAIN
~	+

1.FM Pigtail Antenna

2.AM Loop Antenna Connector

3.Main Speaker Jacks

Using the FM and AM Antennas

Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned prop- erly. Uncoil the FM antenna at the back of the unit, mak- ing sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.

Installation

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

Front View		4 inches
4 inches	5 DISC CHANGER	4 inches
ST

Side View	4 inches
2
inches

AUTOMATIC RECORD LEVEL • AUTO STOP MECHANISM	CONTINUOUS PLAY 2	> 1
ONE TOUCH RECORDING	TAPE DUBBING 2	> 1

ON/STANDBY — Turns power on or off (STANDBY mode).

Tip: In STANDBY mode (press ON/STANDBY off), the system displays the time. Press ON/STANDBY to turn the system on in the previously used mode. Press CD, TAPE, TUNER or AUX (Remote Only) to select the correspon- ding mode. Look at the display icons to identify the current mode.

GAME •MP3• L / R - Jack for auxiliary connection. PHONES — Jack for connecting headphones

OPEN/CLOSE — Opens or closes the disc tray. SOURCE— Selects the CD player/ tuner/ tape player. DIMMER•DEMO/CD DISPLAY — Turns the feature demonstration on or off, adjusts display brightness, selects among displaying disc details.

TIMER — Enters timer setting mode and turns the timer on/off.

CLOCK — Shows clock time and enters clock setting mode.

PRESET EQ — selects among the different EQ modes.

BAND/AUTO PROG. — Changes between FM and AM tuner bands. Enters auto preset program in FM mode.

BASS BOOST — Turns BASS BOOST on or off.

REPEAT - Selects among repeat modes.

DISC SKIP — Skips to the next CD in the tray VOLUME UP/DOWN — Increases/ decreases volume.

Tape Player

RECORD

PLAY

REWIND

FAST-FORWARD

STOP/EJECT

PAUSE

2 3