Kyocera Blade Radio Frequency RF energy Customer support, Battery and charger specifications

Radio Frequency (RF) energy			Customer support
Your telephone is a radio transmitter and receiver. When it			Your service provider’s customer support department may
is on, it receives and sends out RF energy. Your service			be accessible directly from your phone when you dial a
provider’s network controls the power of the RF signal.			number such as *611 (check with your service provider).
This power level can range from 0.006 to 0.6 watts.			They can answer questions about your phone, phone bill,
In August 1996, the U.S. Federal Communications			call coverage area, and specific features available to you,
Commission (FCC) adopted RF exposure guidelines with			such as call forwarding or voicemail.
safety levels for hand-held wireless phones. These			For questions about the phone features, refer to the
guidelines are consistent with the safety standards			materials provided with your phone, or visit
previously set by both U.S. and international standards			www.kyocera-wireless.com.
bodies in the following reports:			For additional questions, you may contact the Kyocera
• ANSI C95.1 (American National Standards Institute,			Wireless Corp. Customer Care Center in any of the
1992)			following ways:
• NCRP Report 86 (National Council on Radiation			•	Web site: www.kyocera-wireless.com
Protection and Measurements, 1986)			•	Email: phone-help@kyocera-wireless.com
• ICNIRP (International Commission on Non-Ionizing			Before requesting support, please try to reproduce and
Radiation Protection, 1996)			isolate the problem. When you contact the Customer Care
Your phone complies with the standards set by these			Center, be ready to provide the following information:
reports and the FCC guidelines.			• The name of your service provider.
E911 Mandates			• The actual error message or problem you are
				experiencing.
Where service is available, this handset complies with the			• The steps you took to reproduce the problem.
Phase I and Phase II E911 Mandates issued by the FCC.			• The phone’s electronic serial number (ESN).
Battery and charger specifications				To find the ESN:
				a. Remove the battery.
Charger	Input	Output		b. Locate the white label on the back of the phone.
CV90-60858-01	100-240VAC / 50/60Hz	4.5V 1.5A		Your phone’s 11-digit ESN begins with “D” and is
				located on the label.
CV90-60859-1	120VAC / 60Hz	5.2V 400mA
			Qualified service
Standard Battery: 3.6V / 900mAh
			If the problem with your phone persists, return the phone
			with all accessories and packaging to the dealer for
			qualified service.

vi