IOGear GBHFK231 manual Restore to Default Settings

Page 28

Restore to Default Settings

1.When the Car Kit is on and in standby mode, press and hold both “+” and “-“ buttons for 10 seconds until the BLUE and RED LED flash 5 times. Then the

Car Kit will enter pairing mode automatically after the reset.

2.When the Car Kit is not powered on, turn on the Car Kit and press and hold both “+” and “-“ buttons for 10 seconds until the BLUE and RED LED flash

5 times. Then the Car Kit will resume standby mode automatically after the reset.

Image 28

Contents Installation Guide Table of Contents Page Package Content Requirements Device Overview Using the USB cable Charging Your Car KitUsing the car charger Page Using solar power Recommended Way of Using Your Car Kit On the sun-visorPage Page Page Page Connect Car Kit to your Bluetooth enabled cellular phone Page Operating the Car Kit with Two Bluetooth enabled phones Activate multi-point connectionPair Two Bluetooth enabled cellular phones Page Switch between two calls on two phones Rejecting call from the second phoneUsing your Car Kit Page Page Transferring Call from phone to Car Kit Device Status LED IndicationLED Status RED LED on LED off Restore to Default Settings Federal Communications Commission FCC Statement Page Page CE Statement Limited Warranty Contact IogearModel Number Serial Number About Us