Before Using Your Device, Quick Setup Wizard

Before Using Your Device

A. Remove the back cover

Hold the device in place with one hand and with your other hand’s thumb or finger, lift up the bottom of the back cover.

Lift from here.

B. Install the SIM Card

C. Install the battery

	Install the battery by inserting	2
	it with its exposed copper part	2
	it with its exposed copper part	Copper conductor
	aligned with the protruding	Copper conductor
	aligned with the protruding
	copper conductor on the	1
	lower-right side of the battery

compartment.

Insert the bottom side of the battery first, then gently push the battery into place.

D. Replace the back cover

E.Charge the battery

The battery is not fully charged out of the box. To charge the battery inside your device, connect the AC adapter plug to an electrical outlet and connect the USB end to the Sync connector on the left side of your device. The battery is fully charged after about 3 hours of charging.

Quick Setup Wizard

When you power on your device for the first time, a Quick Start Wizard will guide you through touch screen calibration, provide a quick tutorial on stylus operation and pop-up menus, and allow you to set the date, time, and a device password.

Follow the on-screen instructions to complete the wizard.

Synchronize Your Device and Computer

Synchronize your device with your computer to keep information such as Outlook e-mails, contacts, tasks, and appointments up-to-date on your device.

Set up synchronization software on your computer

Depending on the Operating System of your Computer, you will need either Microsoft ActiveSync® 4.5 (or later) or Windows Mobile® Device Center to synchronize your device with your computer.

Set up ActiveSync on Windows XP		Set up Windows Mobile Device
1	Install ActiveSync 4.5 on your computer	Center on Windows Vista®

	from the Getting Started Disc.

Cut corner of SIM card

Pull back the red rubber cover.

Insert the SIM card with the gold contacts facing down and the cut corner on the

2outside

Close the red rubber door.

1	Secure the top part of the
	back cover by “locking” it into

	3 openings on the device.
2	Press the middle
	portion of the back
	cover
3	Press the bottom part of the
	back cover to lock it into place.

You should hear a click.

F. Power on/oﬀ the device

Press and hold the POWER button for about 3 seconds to power on your device.

When powering off, a confirmation message will be displayed. Tap Yes to power off the device.

2Connect your device to your computer. The Synchronization Setup Wizard automatically starts and guides you to create a synchronization partnership. Click Next to proceed.

1Connect your device to your computer. In Windows Mobile Device Center, click Set up your device.

The Touch Phone

Earpiece

Touch Screen

Second Camera

Navigation

Control /

ENTER

HTC Home

HTC Home™ is a Today screen plug-in that gives you up-to-date local information at a glance, such as time, date and weather information, and shows new messages and missed calls. It also has a customizable launcher where you can add your favorite applications for one-touch access and a Profile selector where you can quickly change the profile or ring tone of your device.

TouchFLO™

TouchFLO™ gives you better touch panel experience on your device. Using TouchFLO, you can easily scroll and pan the screen by sliding your finger on the touch panel. TouchFLO also has the Touch Cube where you can add your favorite contacts, access media, launch programs, and more.

Finger scrolling

While on a Web page, document, or list (such as contacts list, file list, etc.), slide your finger upward to scroll down; slide your finger downward to scroll up.

To scroll to the right, slide your finger to the left. To scroll to the left, slide your finger to the right.

Finger panning

Configure Data Connections

When you start up your device with a SIM card installed, you see a notification message from the Connection Setup on the Today screen. Connection Setup can help you automatically set data connection settings such as GPRS/3G, MMS, and WAP. Setting up your GPRS/3G connection lets you surf the Web while on the go.

3To synchronize your device with your computer, clear the Synchronize directly with a server running Microsoft Exchange check box and click Next.

2Select the information you want to synchronize and click Next.

Talk

microSD™ card slot

16-key Keypad*

*Slide up the front panel to reveal the keypad.

End

Camera button

Touch and hold on the touch screen and then drag your finger around the screen.

Touch Cube

To open the Touch Cube, slide your finger upward, starting from the bottom of the

touch screen where it shows a logo image.

To close the Touch Cube, slide your finger

downward.

Touch Cube is a three-dimensional, cubic user interface. To flip the interface from one

side to another, slide your finger left or right Opening the Touch Cube on the touch screen.

1When you see the notification message from the Connection Setup, tap Yes.

Note If your SIM card supports multiple network operator profiles, a message will appear with network profile choices. Select the profile you want to use and tap OK.

2Connection Setup then starts to configure your device’s data connection settings.

3After the Connection Setup completes the configuration, tap Restart.

Use Internet Explorer® Mobile (tap Start > Internet Explorer) to surf the Web.

4Select the information types that you want to synchronize, then click Next.

5Choose whether to allow wireless connections while your device is connected to the computer.

6Click Finish.

3Type a name for your device and click Set Up.