RCA RT2500R user manual Speaker Distance, Displaying Program Formats, Setting of the Speakers

RT2500 ENG 5/26/00 2:56 PM Page 17

AdvancedSoundControl

Front Speaker selection	Large/ Small
Center Speaker selection	Large/ Small/ None
Surround Speaker selection	Large/ Small/ None
Subwoofer selection	Yes/ No
Subwoofer Phase	+ / -
Front Speaker distance	0-40 ft
Centre Speaker distance	0-40 ft
Rear Speaker distance	0-40 ft

By pressing the button repeatedly while display is still showing L/R LRG, the display will toggle among: front, center, surround, subwoofer, subwoofer phase and speakers’ distance setup. You can now set the volume size or speakers’ distance by rotating the MULTI JOG.

Note:

•The sub-woofer selection will always be YES when the main speakers are set to small (SML).

•For the subwoofer phase setting, it will be affected by how you locate the subwoofer. Try both + and - settings and select the one that has better bass effect.

Speaker Distance

To make the surround sound more effective and suit the acoustic conditions in your listening room, you need to input the distance of the speakers measured from your favourite listening position. The receiver will adjust the appropriate delay compensation for you.

Main	Centre	Main
Left		Right
	C ch
L/R		L/R
SUR		SUR
Rear		Rear
Left		Right

Note: The receiver has defaulted the following dis- tances:

Main speakers (L/R) 15 ft Center speaker (Cch)*15 ft Rear speaker (SUR) 10 ft

(* Center speaker is available only when Dolby Digital is active)

Speaker Icons EN

The receiver shows you the speakers’ types and set- tings on the display with the following icons:

Small Main Speakers

Large Main Speakers

Small Center Speakers

Large Center Speakers

Small Rear Speakers

Large Rear Speakers

Subwoofer Present

Displaying Program Formats

When a digital source is playing, the receiver will automatically switch to the proper surround mode and indicates on the speaker icons on the right-hand side of the display. (See diagram)

It is important to note, however, that not all Dolby Digital sources are encoded with the full complement

of five channels plus LFE*. Speaker icons show how many and which speaker you have enabled (See “Fine

Setting of the Speakers”) and the

letters inside the speaker icons show which channel is present in the source information. For example, the diagram shown means you have all the five speakers and subwoofer enabled and the digital sources you played have five channels plus LFE complemented.

*LFE stands for Low Frequency Effect. The indication “LFE” appears if the digital source contains LFE information. In this case, the bass signal will be delivered to the subwoofer, offering more dynamic deep bass sound effects. If the letter is flashing, the signal is either too weak or just gone.

13