RCA RS2610 manual Getting Started, EN Unpacking the system, Back View Connecting the Speakers

RS2610-EN rev.1 7/23/02 3:11 PM Page 6

Getting Started

EN Unpacking the system:

You should have the following:

•one main unit (with 2 main speakers);

•one remote control;

•one FM antenna wire;

•one AM loop antenna;

•one user’s guide;

•one safety leaflet;

•Owner and registration Card

Back View

Connecting the Speakers

Match the red wire (on the left speaker) to red terminal for the left speaker (L) on the back of the unit and the black wire (on the left speak- er) to the black terminal for left speaker (L).

Follow the same procedure to connect the right (R) speaker.

Antenna and Speaker Wire Connection

		1
		2		AM LOOP
		AUX IN
		3
		R	L
		4
		R +	+ L
6	5	L+	_
~		+	_
		R

1.FM Antenna

2.AM Loop Antenna Jack

3.AUX IN Connector

4.Surround Speaker Jacks

5.Main Speaker Jacks

6.Voltage Selector

Using the FM and AM Antennas

Before you use your audio system, you’ll want to make sure the FM antenna is positioned properly. Connect the FM antenna to the FM connector on the back of the unit. Uncoil it, making sure it is fully extended (you may even want to tape it to the wall behind the unit, if possible. The higher, the better.)

You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.

Push terminal tab down to	Release tab to lock wire in
insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the Antenna and speaker wires at all connection points.

Installation

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

	4 inches
4 inches	4 inches

Front View

4 inches

2 inches

Side View

2