Ameriphone CA-200, CA-100 manual Specifications, Master Unit

Page 16

Specifications

MASTER UNIT

Maximum Load: 300 watts @ 110 VAC

Max. loop length: 1400 ohms

Ringing Voltages: 53-120 RMS On-Hook Leakage current:

5 micro-amps max. @ 53 volts

Tip & Ring DC Voltage: 53 volts max.

Operating Temperature: 40˚ to 100˚F

Output carrier signal frequency: 100 KHz (other frequencies available from factory).

REMOTE UNIT

Maximum load: 300 watts @ 110 VAC

Operating Temperature: 40˚ to 100˚F

Output carrier signal frequency: 100 KHz (other frequencies available from factory).

E

N G L I S H

13

Image 16

Contents Page Users’ Guide Table Of Contents Important Safety Instructions Read and understand all instructionsUse a damp cloth for cleaning When the power supply cord or plug is frayed or damaged If the product has been exposed to rain or waterNever install telephone wiring during a lightning storm Use caution when installing or modifying telephone linesAdditional Safety Notes for Canadian Users Page Operating Instructions CA-200 only Installation Page CA-200RX Remote Unit Page Specifications Master UnitRegulatory Compliance Part 68 of FCC Rules InformationL I S H Do not Disassemble this Equipment Connected to the telephone line, ensure Repaired and it contains no repairable partsHearing aid compatible Page L I S H Page Is connected Party Responsible for Product ComplianceIndustry Canada Technical Specifications User to disconnect the equipment Rural areasBe connected to a telephone interface. Exceed fivePage Warranty OUT of Warranty Service Your Satisfaction