Weslo WLAW55078 user manual Teries are turned as shown. Replace the battery

5. Turn the Pedal Covers (27) upside-down. Remove	Fig. 5	27
the paper backing from the adhesive strips on the
bottoms of the Pedal Cover.		27
Center one Pedal Cover (27) on the lower end of
the Left Leg (3). Press the Pedal Cover firmly in
place.
Attach the other Pedal Cover (27) to the lower
end of the Right Leg (4) in the same manner.
		4
	3
6. If your Electronic Monitor (50) has a battery cover	Fig. 6
(see figure 6), install batteries as described in this
step. If your Monitor does not have a battery
cover, see step 7 to install batteries. Note: Two
ÒAAÓ batteries (not included) are required. Alkaline
batteries are recommended.		50
Press the tab on the battery cover and remove
the battery cover. Insert two batteries into the
Electronic Monitor (50). Make sure that the bat-
teries are turned as shown. Replace the battery
cover.
		Battery Cover
7. Refer to figure 7a. Remove the two Console	Fig. 7a	Fig. 7b
Screws (48) from the Monitor Bracket (45) and
the Electronic Monitor (50). Lift the Monitor off the
Monitor Bracket. Be careful not to pull the Reed
Switch Wire (47).
Refer to figure 7b. Insert two batteries into the	50
back of the Electronic Monitor (50). Make sure	48
that the batteries are turned as shown.
Refer to figure 7a. Reattach the Electronic Monitor		47
(50) to the Monitor Bracket (45) with the two		50
Console Screws (48).	45
8. Remove the two indicated 3/8Ó x 3/4Ó Screws (23)	Fig. 8	50
from the Right Upright (2). Attach the Monitor
Bracket (45) to the Right Upright with the two	23	45
Screws. Note: If the Electronic Monitor (50) does
not operate properly, see HOW TO ADJUST THE		2
REED SWITCH on page 11.
	7