ASSEMBLY
Place all parts of the DAYBREAK in a cleared area and remove the packing materials; do not dispose of the packing materials until the DAYBREAK is fully assembled. For your convenience, the DAYBREAK can be
assembled in four simple steps. An adjustable wrench 
(not included) is required.
1.Unfold the massage chair to the position shown at the right. Make sure that the Massage Pad (12) is correctly positioned on the Seat Frame (10) and Back Frame (15).
Press one of the Pivot Covers (7) onto the Seat Frame (10). Make sure that the Pivot Cover is turned so the plastic pin inside the Pivot Cover snaps into the indicated hole. Reach under the Massage Pad (12) and press another Pivot Cover (7) onto the Back Frame (15).
Attach the other two Pivot Covers (7) to the opposite side of the DAYBREAK in the same manner (not shown).
2.Attach one of the Arms (9) to the Seat Frame (10) with two 5/16Ó x 2Ó Carriage Bolts (1), two 5/16Ó Washers (4), and two 5/16Ó Nylon Locknuts (5) as shown.
Attach the other Arm (9) to the Seat Frame (10) in the same manner.
3.Connect the wire harness on the Hand Control (14) to the wire harness on the Massage Pad (12). Refer to the inset drawing. Make sure that the indicated latch on the wire harness is engaged. If the wire harnesses do not fit together easily, turn them. Do not force the wire harnesses together.
4.Plug the Power Cord (16) into the jack on the Massage Pad (12).
Make sure that all parts of the massage chair are properly tightened.
1 |
|
|
|
10 |
|
|
|
|
| 7 | 12 |
7 | Hole | 15 |
|
2 |
|
| 9 |
| 9 |
| |
|
|
| |
1 |
| 1 |
|
10 |
|
|
|
4 | 4 |
|
|
|
|
| |
| 5 |
|
|
3 |
|
|
|
|
| 12 |
|
14 |
| Latch |
|
|
|
| |
4 |
|
|
|
| 12 |
|
|
16 |
|
|
|
5