Weslo WLEX28080 user manual

1.Loosen the Frame Knob (29) on the right side of the Frame (1). Slide the Seat Frame (2) out until it stops. Tighten the Frame Knob.

Attach the Stabilizer (30) to the Seat Frame (2) with two M8 x 70mm Carriage Bolts (27) and two M8 Nylon Locknuts (55).

2.Attach the Resistance Control (31) to the Handlebar Post (3) with the Resistance Control Screw (56). Insert the Resistance Cable (70) up through the Handlebar Post as shown.

Next, connect the short cable on the Resistance Control (31) to the Resistance Cable (70) as follows:

¥Insert the tip of the short cable into the wire clip as shown in drawing A.

¥Firmly pull the short cable and slide it into the metal bracket as shown in drawings B and C. Make sure that the tip of the short cable is held by the wire clip as shown.

3.Route both Pulse Wires (59) into the Handlebar Post

(3) and up through the indicated hole. Attach the Handlebar (57) to the Handlebar Post with two M8 x 15mm Button Screws (53) and two M8 x 19mm Washers (54). Make sure that the Screws are threaded into the indicated holes. Do not tighten the Screws yet.

Important: All drawings in this manual show the Handlebar (57) attached to the front of the Handlebar Post (3). However, the Handlebar can be attached to the back of the Handlebar Post, as shown in the inset drawing. Choose the posi- tion that is the most comfortable for you.

4.Connect the two Pulse Wires (59) to the correspond- ing wires on the Console (33). Make sure that the wires with ÒXÓ tags are connected to each other.

If your Console (33) has a ground wire, attach it to the Handlebar Post (3) with a #8 x 1/2Ó Screw (43).

Next, insert the long console wire down through the Handlebar Post (3).

6

1
	29
		55
	1		30
	2
			27
2	Short Cable	31	A
	70
	3		Wire
			Clip
	56
	B		C
3	57
		54	53
	59
	54
	53	Hole
	3
		3	57
4	33
	Console
	Wires
	59	ÒXÓ Tags
	Long		Ground
	Console
		43	Wire
	Wire
		3