ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
¥Assembly requires two people.
¥Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
¥As you assemble the treadmill, be sure that all parts are oriented as shown in the drawings.
The following tools (not included) are required for assembly:
¥Two (2) adjustable wrenches
¥One (1) phillips screwdriver
Assembly will be more convenient if you have the following tools: A socket set, a set of
Screw (10)Ð8
1/4Ó x 1Ó Bolt (23)Ð4
1/4Ó Washer (51)Ð4
3/8Ó x 2Ó Bolt (43)Ð4
3/8" Washer (35)Ð4 | 3/8Ó Nut (34)Ð4 |
1.Note that the Right Handrail and the Console Base (not shown) are connected to the treadmill by a Wire Harness. During assembly steps 1 through 3, be careful not to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the treadmill on its side. Position one of the Base Legs (38) on the base of the Upright (31) as shown. Make sure that the Base Leg Pads (41) and the Front Wheel (39) are in the indicated positions. Attach the Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó Washers (35) and two 3/8Ó Nuts (34).
Carefully turn the treadmill onto its other side. Assemble the other Base Leg (38) as described.
With the help of a second person, carefully raise the treadmill to the upright position so that both Base Legs (38) are resting flat on the floor.
1 | 43 |
39
35
31 41
34
38
5