Diagram of the Console, Battery Installation

DIAGRAM OF THE CONSOLE

Monitor Displays

Speed Control

If there is a sheet of clear plastic on	Key	Clip
the console, remove the plastic.

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turn- ing on the power.

•Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.

•Adjust the speed in small increments.

•The training zones marked around the speed control are general guidelines only. See pages 18 and 19 for more information.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.

BATTERY INSTALLATION

The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. To in- stall batteries, open the battery cover as shown at the right. Press two batteries into the battery compartment,

with the negative (–) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Make sure that the tab locks into place.

Battery

Cover

Tab

Batteries

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 10.)

Stand on the foot pads of the treadmill. Find the clip at- tached to the key (see above), and slide the clip onto the waistband of your clothes. Next, insert the key into the console. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.

Follow the steps on page 12 to operate the console.