Weslo WLTL29820 instruction

3.Insert a Plastic Shim (9) into each side of the post on the right side of the Base (38). Next, hold the Right Upright (15) so the lower end is turned as shown, and insert it into the Base. Make sure that the Wire

Harness (53) does not fall into the top of the Right Upright. Be careful to avoid pinching the Wire Harness. Note: If necessary, tap the Right Upright with a rubber mallet until it is fully seated in the Base. If the Right Upright cannot be fully seated, remove the outer Plastic Shim and then insert the Right Upright.

Attach the Right Upright (15) to the Base (38) with three 1” Bolts (16) and three Star Washers (2). Do not tight- en the Bolts yet.

Assemble the Left Upright (not shown) in the same way.

4.If there are plastic ties in the brackets on the Left and Right Handrails (4, 94), remove them. Hold the Right Handrail near the Right Upright (62) as shown. Insert the Wire Harness (53) up through the bracket on the Handrail and out of the round hole in the side of the Handrail. If necessary, use needlenose pliers to pull the Wire Harness out of the hole. Be careful not to damage the Wire Harness. Insert the brackets into the tops of the Left and Right Uprights (14, 15).

Hand tighten four 1” Bolts (16) with Handrail Washers (7) into the Uprights (14, 15) and the Handrails (4, 94).

5.Set the Console Base (87) on the Left and Right Handrails (4, 94). Thread four 1 1/4” Screws (86) into the Handrails and the Console Base. After you have started all four Screws, tighten the Screws until they are snug; do not overtighten the Screws.

Firmly tighten, but do not overtighten, the bolts used in steps 2 through 4.

Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (87) and up through the hole in the Console Base.

3
		53
		15
			Orient the
			Upright as
			shown.
		9	2 16
		2
		16	38
		16
4		4
		4
		Connectors	94
		16	53
		16
		7
		Bracket
		7
16		14	16
			7
		16	15
			15
5		53	4
	94		4


		87
		Plastic Ties	86
		86	86
		86