Weslo WLTL29013 user manual They are snug do not overtighten the Screws

3. Hold the Console Base (87) near the right Handrail (4).	3
Make a loop with the indicated plastic tie, and insert the				53
two Wires (53) through the loop. Pull out just enough of
the Wires to connect them to the two connectors in the	Plastic
Console Base (87). Plug the Wires into the connectors.				87
	Tie
Important: Make sure that the Wires are fully insert-
ed. WARNING: Do not disconnect or connect the	4
Wires while the treadmill power cord is plugged in.
Refer drawing 3a. Set the Console Base (87) on the	3a			87
Handrails (4, 88). Thread four Console Screws (3) into
the Handrails and the Console Base. After all four
Screws have been started, tighten the Screws until	4
they are snug; do not overtighten the Screws.			53
Feed the excess Wire Harness (53) into the upper end
of the right Handrail (4). Pull the plastic tie tight and cut	Plastic
off the end.		3	88	3
	Tie
4. Attach the Storage Latch (16) to the left Upright (38)	4
with two Latch Screws (14).
		38
Refer to step 2. Tighten the four Handrail Bolts (1).				16
				14

5. Hold a Weight Rack (15) against the right Upright (38) in	5
the position shown. Loosely thread two Rack Screws
	38	15
(14) into the bottom holes in the Weight Rack and the
Upright. Next, loosely thread four Rack Screws into the		14
other four holes. Then, tighten all six Rack Screws.
Set a 3-lb. Weight (not shown) on the bottom hanger on
the Weight Rack (15), a 2-lb. Weight on the middle		14
hanger, and a 1-lb. Weight on the top hanger.
Attach the other Weight Rack and Weights to the left		Hanger
Upright in the same way (not shown).		14

6.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.

6