Weslo WLTL25320 user manual Touch the Right Handrail 59 to discharge any static, Bolts

Page 7

7.Hold the Console (57) near the Console Base (52).

Touch the Right Handrail (59) to discharge any static.

Insert the Wire Harness (60) through the hole in the bot- tom of the Console Base (52). Locate the two wires in the Wire Harness (60) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 7a. Connect the other two wires in the Wire Harness to the back of the Console (57) in the locations shown by the arrows in drawing 7. If the connectors do not fit together easily, rotate them and then connect them.

Make a loop with each of the indicated plastic ties around the Wire Harness (60). Securely tighten each plastic tie to prevent the Wire Harness from slipping. Cut off the ends of the plastic ties.

8.Set the Console (57) in the Console Base (52). Cover the Wire Harness (60) with the Wire Cover (11), and route the Wire Harness out of the hole in the side of the Wire Cover. Attach the Wire Cover to the back of the Console Base with two 3/4” Screws (2). Make sure that no wires are pinched before you attach the Console to the Console Base.

Tighten four 3/4” Screws (2) into the Console Base (52) and the Console (57). Do not over tighten the Frame

Bolts (70).

9.Attach the Storage Latch (48) to the Left Upright (53) with two 3/4” Screws (2).

7

 

 

 

 

 

 

 

57

 

52

 

 

60

 

 

 

60

 

 

 

Ties

7a

 

Tabs

 

 

 

 

 

59

 

 

8

11

52

57

45

59

 

 

 

 

 

 

60

2

 

 

 

 

2

2

 

 

 

 

 

9

 

 

 

 

 

 

 

53

 

 

 

 

2

 

 

48

 

 

 

10.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.

7

Image 7
Contents Model No. WLTL25320 Serial No QUESTIONS?Customer HOT Line Important Precautions Table of ContentsShock Right Side Before YOU BeginFront BackAssembly requires a phillips screwdriver Needlenose pliers AssemblyPage Bolts Touch the Right Handrail 59 to discharge any staticHOW to Plug in the Power Cord Operation and AdjustmentPerformant Lubetm Walking Belt STEP-BY-STEP Console Operation Diagram of the ConsoleBattery Installation AA batteriesCALS/FAT Cals HOW to Change the Incline of the TreadmillHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillProblem The power turns off during use Maintenance and TroubleshootingTop View Problem The walking belt slows when walked on Workout Guidelines HOW to Measure Your Heart RateConditioning Guidelines Exercise IntensitySuggested Stretches Exercise FrequencyLimited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Part Identification Chart Qty Description Part LIST-Model No. WLTL25320DRAWING-Model