3.With the help of a second person, raise the Handrails (6, 7) so the Base (71) is flat on the floor as shown.
Attach the Wheels (15) to the outer sides of the Base (71) with two Wheel Bolts (14) and two Wheel Nuts (A) as shown. Do not overtighten the Wheel Nuts; the
Wheels should turn freely.
Position the front of the treadmill Frame (55) between the Handrails (6, 7) as shown. Next, locate the long wire in- side of the lower end of the Right Handrail (see the inset drawing). Tie the end of the wire securely to the end of the Wire Harness (22). Then, pull the opposite end of the wire until the end of the Wire Harness is extending from the upper end of the Right Handrail.
4.Have a second person lift and hold the front end of the Frame (55). Hold a Frame Spacer (13) between the Right Handrail (6) and the Frame. Attach the Right Handrail to the Frame with a Frame Bolt (10), a Handrail Washer (30), and a Handrail Star Washer (60).
Repeat this step on the left side of the treadmill.
5.Hold the Console (1) near the Right Handrail (6). Touch the Right Handrail to discharge any static.
Untie the wire from the end of the Wire Harness (22). Insert the end of the Wire Harness through the three looped plastic ties. Next, press the end of the Wire Harness into the connector on the back of the Console
(1) in the location shown. The end of the Wire Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and then insert it. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON.
3 |
|
|
7 |
| 6 |
|
| |
|
| A |
|
| 15 |
| 55 | 22 |
|
| |
|
| 14 |
|
| 71 |
|
| 6 |
|
| 22 |
|
| Wire |
4 |
|
|
|
| 6 |
|
| 13 |
|
| 30 |
|
| 10 |
|
| 60 |
|
| 55 |
5 |
| Connector |
|
| |
|
| 1 |
|
| 22 |
|
| Plastic |
| 6 | Ties |
|
| |
|
| 22 |
7