Weslo DS10 guide

8.Hold the Console (1) near the Console Base (77). Touch the right Handrail (32) to discharge any static.

Locate the two wires in the Wire Harness (22) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 8a.

Connect the other two wires in the Wire Harness (22) to the back of the Console (1) in the locations shown by the arrows in drawing 8. The connectors should slide eas- ily into the sockets and snap into place (see drawings 8b and 8c). If the connectors do not slide easily and snap into place, turn the connectors and then insert them. IF

THE CONNECTORS ARE NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

9.Securely tighten a plastic tie around the Wire Harness (22) and under the indicated hook on the Console (1) to pre- vent the Wire Harness from slipping. Tighten the plastic tie and cut off the end.

See drawing 9a. Set the Console (1) in the Console Base (77). Make sure that the Wire Harness (not shown) is not pinched. Next, set the Console Base on the Handrails (32). Insert as much of the Wire Harness as possible into the hole in the right Handrail (32). See step 7. Tighten the plastic tie and cut off the end.

Loosely thread six 3/4” Screws (7) into the Console Base

(77)and the Console (1). Loosely thread four 3/4” Screws into the Handrails (only two Screws are shown). Start all ten Screws and then tighten them; do not overtighten the Screws.

10.Press the Latch Housing (58) into the Left Upright (17). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing, and tighten the knob back onto the pin.

See step 2. Lower the Uprights (6, 17). Tighten the four 3” Bolts (30). Raise the Uprights to the vertical position.

See step 6. Tighten the four 2” Bolts (12). Set a 3-lb. Weight (not shown) on the bottom hanger on the Weight Rack (15), a 2-lb. Weight on the middle hanger, and a 1-lb. Weight on the top hanger.

8	1
	1
77	22
	32
8a	8b	8c
9	1
	1

Hook

Tie

	22
9a	77	1
	77	1
	7
32	7	7	32
10
	Knob
		Spring
		Collar
			Pin
		58
		17

11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The allen wrench is used to adjust the walk- ing belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.