6.Set the Console (10) in the Console Base (46). Be careful to avoid pinching any wires. Insert the excess Wire Harness (21) into the large hole in the side of the right Handrail (1). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Cut off the ends of the plastic ties.
Attach the Console Base (46) to the Handrails (1) with four 3/4” Screws (13); do not overtighten the Screws.
7.Attach the Console (10) to the Console Base (46) with seven 3/4” Screws (13). Make sure that no wires are pinched. Start all seven Screws before tightening them; do not overtighten the Screws. Note: Make sure the in- dicated 3/4” Screw is not overtightened. Overtightening the Screw may cause the Console to not function properly.
6 | 46 | 10 |
| 1 | |
| Ties | |
| 21 | 13 |
13 | 1 |
|
|
| |
7 | 46 | 10 |
|
|
13
Do not overtighten
8. Attach the Storage Latch (14) to the left Upright (76) with | 8 | ||
two 3/4” Screws (13). Be careful not to overtighten the | |||
1 | |||
Screws. |
| ||
|
| ||
See step 3. Tighten the two 2 1/2” Bolts (53). | 76 | ||
|
| ||
See step 4. Tighten the two | lower 1” Bolts (8) (indicated |
| |
by the large arrows) and then tighten the upper 1” Bolts |
| ||
(8). |
| 14 | |
|
| 13 | |
9. Carefully lower the Handrails (1) to the floor. Make sure | 9 | ||
that the Frame (75) is centered between the Handrails. | |||
| |||
Firmly tighten the four 2 1/2” Bolts (53) |
| ||
Raise the Uprights to the vertical position. |
| ||
|
| 53 | |
|
| 53 | |
|
| 75 | |
|
| 1 | |
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
7