ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver | , | ||
two adjustable wrenches | and 9/16 socket wrench | . |
|
1.With the help of a second person, carefully raise the Right and Left Handrails (6, 7) to the position shown. Be careful not to pull on the Wire Harness (22) as you raise the Uprights.
1
22
76
2.With the help of a second person, carefully tip the tread- mill onto its right side. Hold the Base (80) against the Left Upright (7) and the Right Upright (not shown). Make sure the Base Pads (19) are on the bottom.
Using a 9/16 socket wrench and an adjustable wrench, attach the Base (80) to the Left Upright (7) with two Upright Bolts (84), two Washers (11), and two Upright Nuts (17). Do not tighten the Upright Bolts yet. Attach the Base to the Right Upright (not shown) with two Upright Bolts (12), two Washers (11), and two Upright Nuts (17). Then, tighten all four Upright Bolts (84).
Tip the treadmill back to the position shown in step 1.
284
17
7
80
19
11
3.Insert the Wire Harness (22) into the Right Upright (7) as you insert the Handrail (16) into the Right and Left Uprights (7, 6). Be careful not to pinch the Wire Harness. Tighten a Handrail Bolt (12) with a Washer (11) into each Upright.
Loosen the two Console Bolts (9) underneath the Console (1). Rotate the Console to the position shown and tighten the two Console Bolts.
3 |
|
|
1 |
| 16 |
|
| |
12 |
|
|
9 |
| 12 |
11 |
| 11 |
|
| |
6 | 22 | 7 |
|
|
5