4.With the help of a second person, hold the Console Base
(12)and the Right Handrail (32) near the right Upright
(31)as shown. Insert the Wire Harness (28) down into the right Upright; bend the Wire Harness, if necessary. Next, insert the bracket on the Right Handrail into the right Upright. Be careful not to pinch the Wire Harness.
5.Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) into the upper end of the right Upright (31) and the Right Handrail (32). Do not tighten the Bolt yet.
Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) into the lower end of the Right Handrail (32) and the right Upright (31). Do not tighten the Bolt yet.
6.Make sure that the Wire Harness (28) is out of the way of the 1 1/4Ó Screw (97) as you ttach the Console Base (12) to the Handrails (30, 32) with four 1 1/4Ó Screws.
Next, push the Wire Harness (28) down the right Upright (31). It may be necessary to pull the Wire Harness out the bottom of the right Upright.
Tighten all parts used in steps 3, 5 and 6.
7.Remove the backing from the Wrench Clip (91). Press the Wrench Clip onto the base of the right Upright (31) in the indicated location. Press the Allen Wrench (90) into the Wrench Clip.
4 |
|
12 |
|
Bracket |
|
| 28 |
32 |
|
| 31 |
5 |
|
| 23 |
32 | 22 |
| |
| 31 |
22 |
|
23 |
|
6 |
|
28 |
|
32 |
|
97 | 12 |
| |
31 | 30 |
97 | |
7 |
|
| 31 |
| 90 |
| 91 |
8.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
6