Weslo 505S user manual Uprights. Make sure that the Extension Legs remain

2.	With the help of another person, carefully lower the	2	69	66	64
	Uprights (69) as shown. Note: It may be helpful to place
	one foot on one of the Extension Legs [63] as you tip the
	Uprights. Make sure that the Extension Legs remain				39
	in the Uprights.
	Attach each Extension Leg (63) with two 1” Tek Screws			32	57
	(39) and a Round Base Pad (57) as shown. Attach the				57
			66
	lower Tek Screw, without the Round Base Pad, first.
		64
			32
	Attach two more Round Base Pads (57) to the base of		57
	the Uprights (69) with two 1” Tek Screws (39). Note: One				39
			39	63
	replacement Round Base Pad may be included. If a
	Round Base Pad becomes worn and needs to be re-
	placed, use the replacement Round Base Pad.
	Attach the two Wheels (66) with two 2” Bolts (64) and	69	57
	two Wheel Nuts (32) as shown.Do not overtighten the		39
	Bolts. The Wheels should be able to spin freely.	63
	With the help of another person, carefully raise the
	Uprights (69) to the vertical position.
3. Cut the plastic tie holding the Upright Wire (42) in the		3
	right Upright (69).
	Press a Handrail Cap (40) onto the lower end of the	37	71
	Right Handrail (72) as shown. Attach the upper end of
	the Right Handrail to the right Upright (69) with a 2 1/2”		69	72
	Bolt (37). Be careful not to pinch the Upright Wire.
				42
	Firmly tighten the Bolt. Attach the lower end of the
	Right Handrail and the Handrail Cap with a 3/4” Tek			37
	Screw (58) and a Washer (38).
	Attach the Left Handrail (71) in the same way. Note:
	There is not an upright wire on the left side.
					69
			40
		38
		58
			40
			38
			58

7