Using the 3D Glasses
Switching to 3D and 2D Mode
When viewing 3D images, you can slide the switch between 2D and 3D modes. This is useful when several people are viewing 3D images on the same TV with some people wanting to watch in 3D and some people wanting to watch in 2D.
■Viewing 2D images
When you slide the switch to 2D while viewing 3D images, the 3D images switch to 2D images.
■Viewing 3D images
When you slide the switch to 3D while viewing 2D images, the 2D images switch to 3D images.
Usage Range of the 3D Glasses
The 3D Glasses can be used by receiving an infrared signal sent from the TV.
The 3D Glasses turn off automatically after 10 minutes if no signal is received from the TV.
■Operating range
From directly in front of the 3D infrared emitter on the TV: approx. 5 m (within approx. 30° horizontally and 20° vertically)
Recharging the 3D glasses battery
When the battery power is low, the LED light blinks one time per second. If the 3D glasses battery runs out, you can recharge the 3D glasses battery by connecting the supplied USB cable to the TV and the
1Turn off the TV, and then slide the switch on the 3D glasses to OFF.
2Connect the cable shown below before turning on the TV.
•The LED light blinks once per two seconds, and then starts recharging.
•When the LED light goes off, the recharge is complete. It takes 90 minutes to complete the recharge.
•Insert the USB cable again if the LED light blinks on and off once every 0.5 seconds. If it still doesn’t respond, inquire with a retail dealer or SHARP customer service.
3After the recharge has completed, turn off the TV, and then remove the USB cable from the 3D glasses.
1USB cable (supplied accessory)
2
CAUTION
• Do not recharge while wearing the 3D glasses.
NOTE
•Be sure to turn on the TV when you recharge the 3D glasses battery. If the TV is turned off, you may not recharge it.
•When you recharge the 3D glasses battery, only connect the USB cable (supplied accessory) to a USB terminal on the TV.
•The battery will not recharge during usage with the USB cable connected.
•Recharge the battery within the operating temperature
Using the 3D glasses with an external power supply
You can use the 3D glasses with an external power supply when you slide the switch on the 3D glasses to 3D or 2D after steps 1 and 2 in Recharging the 3D glasses battery (recharging will not complete).
NOTE
•Do not move around while wearing the 3D glasses. You may result in getting your feet caught in USB cable, the TV falling or other accidents that may cause injury.
•When you supply power to the 3D glasses, only connect a USB cable (commecially available) to a USB terminal on the TV.
•When you use the USB cable connecting the 3D glasses, careful not to get your feet caught in the USB cable. It may result in falling or other accidents that may cause injury.