Newcon Optik Phantom 150 operation manual Construction, AT Insufficient Ambient Illumination

NOTE : As the design is being continuously improved some descriptions may differ from those given above.

4. CONSTRUCTION

3 4 5 1 2

8

		7	6
	9	10
1-	Body
2- Lens Focusing Ring
3-		Eye-piece

4- Switch Button for the Scope

5- IR Illuminator Switch

6- IR Illuminator

7- Battery House Cover

8- Lens Cover

9- Carrying Strap

10- Low battery indicator

8

5.OPERATION INSTRUCTIONS WARNING!

NEVER OPERATE YOUR NIGHT VISION DEVICE IN DAYLIGHT AREAS WITHOUT THE LENS COVER ON ! NEVER DIRECT THE LENS IN THE DIRECTION OF BRIGHT LIGHT !

5.1 Pre-starting procedures.

1.Unpack the device. In order to replace the battery unscrew battery house cover (7) and replace the battery observing the polarity indicated; close cover (7). First, make sure the lens cap (8) is closed: Check the functioning of the device by switching it on (click switch 4) and looking through eye-piece (3). If power supply and the battery is O.K., you will see greenish lit screen. If the screen is not lit, check the battery. Replace the battery if necessary. If everything works, now is a great time to fill the warranty card. You can find the unit’s serial number on the button.

5.2.Testing of operation

Turn on the device using switch (4). Lens cap (8) must be on. Direct the device on an object placed within 40-50 m from the viewer. Turning the eye-piece (3) try to achieve the sharpest image on the screen of the image tube. For close focusing rotate the front lens (2)

5.3.Operation at night

AT MOON LIGHT: Unscrew the lens cover (8). Turn on the device using switch (4). Turning the eye-piece focusing lever (3) adjust to achieve the most clear image on the screen. Then obtain the most clear- cut image of the object focusing with ring,(2). Repeat the steps of focusing if necessary.

Note: The ON button is equipped with automatic shut off circuitry. After a while, it will shut itself off, to prevent battery drain.

AT INSUFFICIENT AMBIENT ILLUMINATION

Activate switch (4) for switching on the device. Press button (5) for switching on IR illuminator. Direct the device on the object to be viewed.

Note: The I/R button is equipped with automatic shot off circuitry. After a while, it will shot itself off, to prevent battery drain.

9