Newcon Optik NVS 7 technical specifications Components, Using the helmet mount optional

Figure 7

1 – locking screw; 2 – flip/flop button; 3 – flip-flop adjusting screws; 4 – mount binding screw

2. COMPONENTS

NVS 7 is supplied with the following components:

PART	QUANTITY
NVS 7 unit with 1x lens *	1
Head gear*	1
Lens caps	1
Manual	1
Warranty registration card	1
Optional parts **
PART	QUANTITY
3x add-on lens	1
4× lens	1
8x lens	1
Sacrificial lens	1
Demist shields	2
Soft case	1
Hard case	1
Neck strap	1
Lens brush	1
Lens cloth	1
AA batteries	2

*In a binocular configuration the unit is supplied with 4x or 8x lens without head gear, and without 1x lens

**Exact delivery set and accessories included are

subject to the terms of specific sales contract.

5.5Using the helmet mount (optional)

NVS 7 can be equipped with an optional helmet mount. This mount is customized for a particular type within the wide variety of existing helmet models. The mount is attached to a helmet with stripes. The goggles are fixed to the mount by a locking screw (1). Adjust the goggles position on your eye level with the screw (4).Then adjust the

eye-relief (the distance between your eyes and the eyepieces), which should be about 25 mm. In order to achieve this, loosen locking screw (1) and set a comfortable distance between the eyes and the eyepieces; then tighten the

locking screw back.1 2 3 4 You can fixate the unit in

three predetermined positions: vertical, horizontal, and 15-20 degrees above horizontal. The angles between these positions cannot be changed,

but the starting point is adjusted by screws (3). If you loosen them, you can rotate the flip-flop mechanism to find the most suitable starting fixating point. Don’t forget to tighten the screws

(3) after adjustment.