Newcon Optik BN 5 operation manual Warranty, Unit flashes, Condensation accumulates on the parts

Page 3

If the view still does not seem in focus, clean the lenses; they could be foggy or dusty.

Unit flashes

It is normal for the unit to flash within the first 2 minutes of activation. If the flashing continues afterwards the following is a possible cause: bright environment (even with the caps closed!)

Condensation accumulates on the parts.

It is O.K. to use the unit in cold. However, when the unit is brought from the cold into a warm environment, it has to warm up for up to 2 hours (not minutes!). Only then it is allowed to turn it on again.

Visibility decreases and / or disappears.

Bright light sources (moon, projectors or headlights) may cause visibility to degrade or even completely disappear. Move the binoculars away from the light source immediately. The image should be restored in within 2 minutes.

Poor atmospheric conditions such as fog, haze or extremely dark environments will decrease the visibility distance of the unit.

8. WARRANTY:

NEWCON OPTIK warrants this product against defects in material and workmanship for one year from the date of the original date of consumer's purchase, but no more than 18 months from the date of manufacturing. Should your NEWCON product prove defective during this period, please bring the product

10

NEVER disassemble the unit. This device contains high voltage, which may be hazardous to your health!

NEVER expose the opened objective lens of the activated unit in daylight. (Note: 1st generation units remain active for a few minutes after switching the unit off). If you test the device during daytime, caps must cover the objective lenses. There is a tiny hole in the lens caps to provide enough light for such testing.

NEVER aim active unit at intense light sources (i.e. lights, headlamp, campfires, the moon, etc.)

NEVER reverse the batteries polarity.

NEVER connect the unit to external power sources.

ALWAYS keep the objective lenses covered when not in use

ALWAYS store in a warm dry place when not in use

ALWAYS remove battery when not in use for a long period

THANK YOU

FOR PURCHASING THE NIGHT VISION BINOCULAR BN 5. PLEASE

DEMAND TO CHECK THE DEVICE FOR PROPER OPERATION WHEN BUYING IT. PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE USING.

3

Image 3
Contents Acceptance Certificate Night Vision Device Customer SupportImportant Information ContentsVisibility decreases and / or disappears WarrantyUnit flashes Condensation accumulates on the partsBinocular does not work TroubleshootingOverview Operation at NightOperation Instructions Warning Pre-starting proceduresDaytime testing PrecautionsSpecifications of BN ComponentsConstruction